Search the Community
Showing results for tags 'FG Tour V5'.
Found 1 result
My goal was to get out and play today to give a full review of this driver on the course but the weather has been so cold and rainy that it hasn't been possible yet. Instead I took the driver up to Golfsmith to get on their launch monitors and at least have some numbers to post. It took me a little while to get warmed up since I haven't swung a club in a few weeks but overall the club performed extremely well for me. I am very pleased with how low the spin stayed since I normally have a hard time getting below 3000 rpm's. I usually swing around 100 mph and currently play to a 3.8 handicap. My shot shape is pretty straight overally but I tend to favor a slight fade so my spin numbers are usually a little higher. I was a little scattered with my impact position on the face as you can see from my picture but for not playing in so long, I wasn't too upset. The driver shaft length was a little long (almost 46") and the swingweight was around D5. I usually prefer no longer than 45" and a swingweight of D2. The sound was a little hollow sounding but nothing obnoxious at all. It may also have sounded differently because I was in the fitting area indoors. Overall my averages were: Clubhead Speed: 100 mph Ball Speed: 145.6 mph Launch Angle: 14.7 degrees Backspin: 2298 rpm Total Spin: 2352 rpm Total Carry: 250.2 yards Total Distance: 274.19 yards Offline: 5 Yards Given these numbers I'm pretty excited to see what it does out on the course. I'm sure using real golf balls my spin will decrease some compared to whatever they have in the fitting area. Once I got home I shortened the shaft down to 45" and added a few grams of hot melt through the screw weight port. This should help the sound quite a bit and gave me my desired swingweight after I cut it down.