Jump to content
TESTERS WANTED! ×

Raw finish vokey wedge


beegee76

Recommended Posts

You should repost this thread to the DIY area, someone will likely see it there and have some tips. We have some good club builders here, and lots of others with good knowledge on these things, they probably just haven't seen this.

Lefties are always in their Right Mind

Link to comment
Share on other sites

Etch and Prep (Phosphoric Acid) can be found at home depot and removes the black or copper based finishes in less than two minutes. Coke and Vinegar are not nearly as concentrated acid content  and take much longer to strip the finish. Just clean the wedge thoroughly, soak the club head to just below the ferrule for 120 seconds, remove and apply baking soda to neutralize the acid, and it's all done. Be sure to wear gloves/goggles while handling the acid. It can be reused as well. Good luck.

F9 Tensei Pro Orange 70TX

Taylormade Tour M2 15* / Kuro Kage 80 TX

790 UDI Tensei White 100TX

Apex Pro 19 4-PW DG X7

Vokey SM7 Raw 50* 54* 

Taylormade Hi-Toe 60* S400

Taylormade Spider Tour (Red)

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...