"True Temper High Performance Graphite"

[DK03]

Putting a set together for a buddy. He bought these online. I'm looking for trimming instructions, but failing to find those, I'm looking for anything about these.

Anyone have any information on these? 

[jaskanski]

10 shafts would equate to 1 iron through to PW. Using the ubiquitous TT trim code iH1 for standard bore insertion:

1 = 0

2 = 0.5"

3 = 1.0"

4 = 1.5"

5 = 2.0"

6 = 2.5"

7 = 3.0"

8 = 3.5"

9 = 4.0"

PW = 4.25"

I'm guessing each shaft has a raw length of 39"-40"? Butt trim to desired playing length. Done.

[DK03]

Appreciate this.

Any idea why I can't find anything about these online? When did they come out? Were they discontinued?

[jaskanski]

TT has made literally hundreds of shafts that are no longer in production. They also made shafts through the PFC (performance fitting centre) and even acquired Accra I think.

[RickyBobby_PR]

I have never seen that shaft. Best bet is to contact true temper

[DK03]

7 minutes ago, RickyBobby_PR said:

I have never seen that shaft. Best bet is to contact true temper

Thought the same. I'm just awaiting a response. 

[Dazzle]

I have been thinking of purchasing the same shafts. Let me know what True Temper say. I was worried they may be hybrid shafts and not have enough parallel tip length to trim for the shorter irons. If 5 iron requires 2 inch tip trim, 9 iron would require 4 inch tip trim and PW 4.25 inch minimum. You need another 1.25 inch bore insertion depth. So a minimum of 5.5 inch of parallel shaft.