Project X Small batch sticker on non-small batch driver shaft?

[Bucky CC]

Just picked up a Project X EvenFlow Riptide CB shaft to go along with my standard Riptide shaft.  When I was removing the pre-installed grip I noticed the manufacturer's sticker references it being a small batch shaft.  The only problem is the shaft itself is not labeled as small batch.  Any idea what's going on?  I can't imagine it's that difficult to print a shaft specific sticker.

Sorry for the terrible picture quality.  The label stuck to the grip tape and it's kind of hard to see.  All other data referenced on the sticker (46", Counter Balance, 60g, 6.5 flex) is correct.

And here's the actual shaft.

And for comparison's sake my small batch regular Riptide shaft with Small Batch label clearly showing.