SHAFT TIP TRIMMING WHEN USING AN RBZ ADAPTER SLEEVE

[Bobber]

Hey guys,

When reshafting an RBZ driver with its adapter sleeve...would you tip to allow for the sleeve?

[Super Tuna]

TM doesn't when they do their installs

[Bobber]

TM doesn't when they do their installs

Really... That's good to know. Thanks T!

[RookieBlue7]

Actually, TMag does at times, at least at the Kingdom locations and on the van. But it varies by shaft manufacturer.

 

You're better off calling the shaft manufacturer and asking them their recommended tipping for that shaft into a shaft adapter. Some will say none, some will say 1/2", a few will say 3/4" to play to the stated flex. Your answer is "it depends".

[Super Tuna]

Actually, TMag does at times, at least at the Kingdom locations and on the van. But it varies by shaft manufacturer.

 

You're better off calling the shaft manufacturer and asking them their recommended tipping for that shaft into a shaft adapter. Some will say none, some will say 1/2", a few will say 3/4" to play to the stated flex. Your answer is "it depends".

 

Off the van and the Kingdom, sure. As a standard TP shaft ordered through anyone else? No. Per Dave that introduces too many operational variables to be screwed up (though he used more flowery and less direct language, that was the gist).

 

But yeah, if he's worried he can call the shaft OEM and check with them.